Model library › The bathtub

The bathtub

Why the water keeps rising after you turn the tap down: the simplest stock and flow there is.

Everyday lifeSchool2 stocks · 3 flows · 5 convertersRuns for 40 minutes

Open it, press Play, then move the sliders and compare the scenarios.

What the model shows

A bathtub is a stock: it fills when more water comes in than goes out, and empties when more goes out than comes in. Try this: the tap is turned down after 5 minutes, but the water still keeps rising for a while. Why? Because the level only falls when the drain takes away MORE than the tap brings. Change Tap_Later and the plughole size (Drain_Speed) and watch where the level settles. Then make the plughole small (0.05) and keep the tap at 12: the tub fills up to the rim and the rest runs over onto the floor. Overflow is a flow too. Time unit: minutes.

Scenarios to compare

  • Turn down to 9
  • Turn off completely
  • Small plughole: overflow

What is in the model

  • Water in TubHow much water is in the bathtub. It only changes through the tap and the drain.
  • Water on the FloorWater that ran over the rim. A stock nobody wanted.
  • DrainWater running out of the plughole. More water in the tub pushes harder, so it drains faster.
  • OverflowWhen the tub is full, whatever the drain cannot take runs over the rim.
  • TapWater coming in from the tap.
  • Drain SpeedShare of the water that drains away each minute (the plughole size).
  • Tap FullHow fast the tap runs at first.
  • Tap LaterHow fast the tap runs after you turn it down.
  • Tub SizeHow much the tub holds up to the rim.
  • Turn Down TimeWhen you turn the tap down.